Datasheet

(Request for description from the designer - the pieces don't actually snap together, so I can't tell if
there's any way to use the connectors on the edges. Are they meant to connect to header pins on a
metric-spaced breadboard? Are they meant to connect I2C Grove units together, or are there other
reasons to connect non-I2C Grove units like that?)
A circuit diagram would look really nice here.
Next, let's examine each of our “Grove units”, and then use each on in an example Arduino sketch that
we can use with our Seeeduino boards...
Button
This new version of button Grove contains one independent button, which are configured with pull-
down resistor – ready for use with our microcontrollers as digital input. The button signals the SIG
wire,NC is not used on this Grove .
Tilt switch