User's Manual
Table Of Contents
- 1. Introduction
- 2. Development Environment
- 2.1. Operating Systems
- 2.2. OpenWrt Introduction
- 2.3. Network Environment
- 2.4. System Configuration
- 2.4.1. Accessing Web UI
- 2.4.2. Accessing System Console
- 2.4.3. Using SSH (Secure Socket Shell)
- 2.4.4. Using Serial to USB Cable
- 2.4.5. Upgrading Firmware
- 2.4.6. Upgrading bootloader
- 2.4.7. Wi-Fi Reset
- 2.4.8. Factory Reset
- 2.4.9. Connecting LinkIt Smart 7688 To a network with Wi-Fi Access Point
- 2.4.10. Open a system console and enter the following commands to change LinkIt Smart 7688 to station mode ( For more information on system console, please see 2.4.1 “Accessing Web UI
- 2.4.11. Viewing System Information from the Web UI
- 2.5. Accessing the USB drive and the SD card
MediaTek LinkIt™ Smart 7688 User Manual
Figure 1 LinkIt Smart 7688 development board (MPU only)
1.3.2. Buttons
The buttons description on LinkIt Smart 7688 and how to use them are
described in Table 2.
Scenario Button Action
Resets the MPU MPU Reset Button One Press
Resets Wi-Fi to
AP mode
Wi-Fi Reset
Button
(After system is
boot up)
Press for at
least 5 seconds
and release
Factory resets
and enters AP
mode
WARNING:
Restore to
default setting
and all user
data will be
Wi-Fi Reset
Button
(After system is
boot up)
Press for at
least 20 seconds
and release
© 2015, 2016 MediaTek Inc.
Page 4 of 38
This document contains information that is proprietary to MediaTek Inc.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.