User's Manual
Table Of Contents
- 1. Introduction
- 2. Development Environment
- 2.1. Operating Systems
- 2.2. OpenWrt Introduction
- 2.3. Network Environment
- 2.4. System Configuration
- 2.4.1. Accessing Web UI
- 2.4.2. Accessing System Console
- 2.4.3. Using SSH (Secure Socket Shell)
- 2.4.4. Using Serial to USB Cable
- 2.4.5. Upgrading Firmware
- 2.4.6. Upgrading bootloader
- 2.4.7. Wi-Fi Reset
- 2.4.8. Factory Reset
- 2.4.9. Connecting LinkIt Smart 7688 To a network with Wi-Fi Access Point
- 2.4.10. Open a system console and enter the following commands to change LinkIt Smart 7688 to station mode ( For more information on system console, please see 2.4.1 “Accessing Web UI
- 2.4.11. Viewing System Information from the Web UI
- 2.5. Accessing the USB drive and the SD card
MediaTek LinkIt™ Smart 7688 User Manual
you’re using Windows 7, you’ll need to install Bonjour printing service to
help your computer discover LinkIt Smart 7688 (IP address) when in Station
mode on a local area network with a Wi-Fi AP.
2.4.1. Accessing Web UI
LinkIt Smart 7688 Web UI allows you to configure system information,
upgrade firmware, perform device reset and change between Wi-Fi AP and
Client mode and more. The following steps apply to Windows, Mac OS X and
Linux.
1) Power on LinkIt Smart 7688 by using any USB power source,
for example your computer and a Micro USB cable as shown in
Figure 11.
Figure 11 Connecting LinkIt Smart 7688 to a computer
2) Click the Wi-Fi icon on your computer and connect to an
access point named LinkIt_Smart_7688, as shown in Figure 12.
Figure 12 Connecting to LinkIt Smart 7688 AP
3) Open a web browser and type http://myLinkIt .local in the URL box.
The Web UI page opens as shown in Figure 13.
© 2015, 2016 MediaTek Inc.
Page 22 of 38
This document contains information that is proprietary to MediaTek Inc.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.