User's Manual

6. Return status \r\n+BTSTA:xx\r\n
xx status:
0 - Initializing
1 - Ready
2 - Inquiring
3 - Connecting
4 - Connected
(Note: This is not a command, but the information returned from the module after
every command)
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:


 Reorient or relocate the receiving antenna.


 Increase the separation between the equipment and receiver.


 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.


 Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
OEM Installation Instruction
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment is installed and operated without distance limited between the radiator
& your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This device is intended only for OEM integrators under the following
conditions:
The transmitter module may not be co-located with any other transmitter or antenna.