Users Manual

FCC ID: Z4T-WM1302-C
Conditions on using Seeed regulatory approvals:
A. Customer must ensure that its product (the“CUSTOMER Product”) is electrically identical to Seeed reference
designs. Customer acknowledges that any modifications to Seeed reference designs may invalidate regulatory
approvals in relation to the CUSTOMER Product, or may necessitate notifications to the relevant regulatory
authorities.
B. Customer is responsible for ensuring that antennas used with the product are of the same type, with same or
lower gains as approved and providing antenna reports to Seeed.
C. Customer is responsible for regression testing to accommodate changes to Seeed reference designs, new
antennas, and portable RF exposure safety testing/approvals.
D. Appropriate labels must be affixed to the CUSTOMER Product that comply with applicable regulations in all
respects.
E. A user ’s manual or instruction manual must be included with the customer product that contains the text as
required by applicable law. Without limitation of the foregoing, an example (for illustration purposes only) of
possible text to include is set forth below:
1. USA—Federal Communications Commission (FCC)
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
INFORMATION TO USER:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by tuning the equipment off and on,
the user is encouraged to try and correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
System integrators must include the FCC ID on the end product.
FCC Radio-Frequency Exposure & Approval Conditions:
1. Transmitting antenna(s) can only be installed at the display section of computer. When this device is installed
other than notebook computers, at least 20 cm separation distance shall be maintained between the transmitting
antenna(s) to the body of user or nearby person.
2. The antenna(s) used for this transmitter must not be collocated or operating in conjunction with any other
antenna or transmitter within a host device, except in accordance with FCC multi-transmitter product procedures.
3. The regulatory label on the final system must include the statement: “Contains FCC ID: Z4T-WM1302-C”using
electronic labeling method as documented in KDB 784748.
4. The final system integrator must ensure there is no instruction provided in the user manual or customer
documentation indicating how to install or remove the transmitter module except such device has implemented