User manual

RF Explorer User Manual page 11
o Using buttons UP and DOWN on this screen will increase or decrease the selected RF power,
one step at a time.
For instance if the unit is in Attenuator:1 and Switch:0 (lowest possible power) a press on the
UP button will increase into Attenuator:1 and Switch:1. Another press will increase to
Switch:2, etc.
The Switch is sequentially increased up to the max level Switch:3 and, if the Attenuator is 1
at that point, it will be disabled to increase the power in the next increment with UP button.
For instance if the unit is in Attenuator:1 and Switch:3, the press of UP button will increase
to Attenuator:0 and Switch:0. See RF power section Understanding RF Power Modes on page
17 for more details on power level modes.
o Using ENTER key enables and disables RF output power
o Using MENU key goes to the last used menu. Note: if the RF power was enabled, MENU will
automatically disable it to avoid unattended power signal to be active. You can re-enable
power once you get back from MENU configuration.