Instructions

RF Explorer Signal Generator User Manual page 9
Connecting RF Explorer Signal Generator
The unit includes 50 ohm impedance RF connector standard SMA format.
 The RFE6Gen baseline model includes only one connector, the RF SMA on the left in the above
image. This manual will indicate specifics for this model whenever is different from Combo model.
 The RF Explorer Signal Generator Combo model includes two SMA connectors, but only the
enhanced functionality of the SMA connector on the right side is enabled. A future firmware may
enable both connectors to allow double signal source but with different capabilities. It is
recommended covering the left SMA connector with a dummy load 50ohm for better protection.
The unit will automatically start running on USB power when a compatible mini-USB cable is connected.