Instructions

RF Explorer Signal Generator User Manual page 26
Frequency Sweep mode
The RF Explorer Signal Generator Frequency Sweep mode allows iterative hops over Start Frequency and
Stop Frequency defined by a Step Frequency and a Step delay.
Signal Generator RFE6GEN baseline model offers power levels limited to 8 values, whereas Combo model
offers advanced power selection with 0.25dB resolution, as described in Power Menu (Combo model)
section. Power screens below are depicted for RFE6GEN baseline model but are equivalent for Combo
model.
To start the Frequency Sweep, press ENTER key. The Sweep will be active until ENTER is pressed again.
In above example, Frequency Start is 1,100.000MHz and Frequency Stop is 1,200.000MHz. The nominal
power level is -31.7dBm with High Power:OFF and Level:2. Using UP and DOWN button will change power
level one step at a time.
The Frequency Step and Step delay used for the sweep is defined in the FREQUENCY MENU.