Instructions

RF Explorer Signal Generator User Manual page 18
Operational Mode menu
The menu displays different functional modes available in your Analyzer.
Use [Up] and [Down] arrow keys to select the desired mode and click on [Enter] to activate it immediately.
 RF Generator mode is the default mode, this is used for carrier CW signals
 Frequency Sweep allows iterative hops over Start Frequency and Stop Frequency defined by a Step
Frequency and a Step delay.
 Amplitude Sweep allows iterative amplitude change at CW frequency.
 RF Connections enumerates the installed RF modules and how each one is connected to each SMA
RF port. This example below shows a standard RFE6GEN baseline model with 24 to 6000MHz. Click
on any key to get out of this screen.
With RF Explorer Signal Generator Expansion board installed (Combo model) the screen will display
this information: