Instructions

RF Explorer Signal Generator User Manual page 12
The available indicators are:
 Selected CW frequency: This is the currently selected carrier (or CW) frequency, expressed in GHz,
MHz and KHz. It can be modified in the FREQUENCY MENU.
 Power Level: This is the actual output power selected in Power Menu for CW. With selective value as
fine as 0.25dB this can go in ranges from -60 to +20dBm, but only -40 to +10dBm are calibrated
ranges. Note: an upgrade firmware will display a special mark to indicate calibrated vs uncalibrated
range.
 Action Indicator (current power mode): The Signal Generator display the current status of the RF
output signal, at the selected frequency and selected power level. By clicking on ENTER key the
power signal will be delivered to the RF output port, and the screen will clearly indicate that with RF
POWER ON message.
Please note standard precaution of RF power delivered without a connected load.