User manual

（2）Measure peak-to-peak voltage of the signal source.

Please operate according to following steps:

!Use “▲” or “▼” to choose Yn items in Measurement Area

!Press “OK”

!Use “▲” or “▼” to choose CursorV1

!Use “◄” or “►” to adjust the position of CursorV1 to the crest

!Use“▲” or “▼”to choose CursorV2

!Use “◄” or “►” to adjust the position of CursorV2 to the valley

And get：△V=2.08V. i.e. the peak-to-peak voltage of signal source, as shown in the image below:

3. Example Three：Save waveform image

Sometimes waveform images need to be archived or analyzed on PC platform.

Please operate according to following steps:

!Use “▲ ” or “▼ ” to choose the Fn items in Measurement Area, press “OK”, use“▲” or “▼” o choose Save

Bmp, and then use “◄” or “►” to choose the file name on the lower right corner of the screen ,e.g.Save000.BMP，

as shown in the image; and then press“!||” to save it to the built-in U disk.

!Just copy the image to your PC, and you can analyze the waveform image.