User manual

parameters that need analysis, e.g. Freq(frequency), Duty(dutyfactor), Vpp(peak-to-peak voltage)etc., the

measured value will be displayed at the lower right corner of the screen, as shown in the image below:

2. Example Two： Measure with Cursor

A cursor can be used to measure the time and voltage of the waveform very quickly.

（1）Measure the cycle of signal source

Please operate according to the following steps:

!Use “▲” or “▼”to choose Xn items in Measurement Area.

!Press “OK”

!Use “▲” or “▼” to choose CursorT1

!Use“◄” or “►” to adjust the position of CursorT1 to the crest.

!Use “▲” or “▼” to choose CursorT2

!Use“◄” or “►” to adjust the position of CursorT2 to the next crest.

And get：△V=1.00mS i.e. the cycle of signal source. As shown in the image below:

Measured value