Grove - Servo Release date： 9/20/2015 Version： 1.0 Wiki: http://www.seeedstudio.com/wiki/Grove_-_Servo Bazaar: http://www.seeedstudio.com/depot/Grove-Servo-p-1241.
Document Revision History Revision Date Author Description 1.0 Sep 21, 2015 Victor.
Contents Document Revision History ···································································································2 1. Introduction ···················································································································2 2. Features··························································································································3 3.
Disclaimer For physical injuries and possessions loss caused by those reasons which are not related to product quality, such as operating without following manual guide, natural disasters or force majeure, we take no responsibility for that. Under the supervision of Seeed Technology Inc., this manual has been compiled and published which covered the latest product description and specification. The content of this manual is subject to change without notice.
1. Introduction Grove - Servo is DC motor with gearing and feedback system. It is used in driving mechanism of robots. The module is a bonus product for Grove lovers. We regulated the three-wire servo into a Grove standard connector. You can plug and play it as a typical Grove module now, without jumper wires clutter. But if you feel more like a proto servo, check out EMAX 9g ES08A High Sensitive Mini Servo. They are the same model, both of good quality and burden-free price.
2.
3. Specifications Item Min Typical Max Unit Working Voltage 4.8 5.0 6.0 V Torque 1.5/1.8 Kg.cm Speed 0.12/0.16 s/60° Size 32X11.5X24 mm Weight 8.
4. Usage The Servo has three wires: power, ground, and signal. The power wire is typically red, and should be connected to the 5V pin on the Arduino/Seeeduino board. The ground wire is typically black or brown and should be connected to a ground pin on the Arduino board. The signal pin is typically yellow, orange or white and should be connected to Digital 9 on the Arduino board.You can change to the digital port as you like.
5. Support If you have questions or other better design ideas, you can go to our forum or wish to discuss.
