Datasheet
61
This device complies with Part 15 of the FCC`s Rules. Operation is subject to the following two Conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesirable operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20cm between the transmitter’s radiating structure(s) and the
body of the user or nearby persons.
This module is intended for OEM integration. The OEM integrator is responsible for FCC compliance and compliance with all
applicable regulations including those for modular transmitters 47 C.F.R. 15.212. The OEM product must comply with all
applicable labeling requirements including those contained in 15 C.F.R. 15.19. The OEM is solely responsible for certification
and testing and labeling of its own products. In addition to any independently required labels, the OEM shall also affix to the
outside of a device into which the module is installed a label referring to the enclosed module. This exterior label should be
prepared in a legible font and permanently affixed and using the wording “Contains Transmitter Module FCCID:
A3LSIP005AFS30”
The OEM is required to ensure that the end product integrates this module so as to maintain a minimum distance of 20 cm
between the equipment’s radiating structure(s) and the body of the user or nearby persons. The OEM shall also advise its end
user of this requirement as required by applicable rules.
The OEM shall require that the end user of its product be informed that the FCC radio frequency exposure guidelines for an
uncontrolled environment can be satisfied. The OEM shall further inform its end user that any change or modifications to this
module not expressly approved by the manufacturer will void the warranty and the users’ authority to operate the
equipment.