Datasheet

 Slave Mode : Support Tx up to 8MHz, Rx up to 8MHz

The ARTIK 530 Module provides three 2-pin universal asynchronous receiver transmitters (UARTs). The key features of the

UART sub-system are:

 Separate 32x8 Tx and 32x12 Rx FIFO memory buffers

 Support for DMA mode (UART0 : [AP_UART_RX0, AP_UART_TX0] only) and interrupt based mode of operation

 All independent channels support IrDA 1.0

 Support for modem control functions CTS, DCD, DSR, RTS, DTR and RI

 Each UART channel contains:

 Programmable baud-rates

 1 or 2 stop bit insertion

 5-bit, 6-bit, 7-bit, or 8-bit data width

 Parity checking

The ARTIK 530 Module provides three generic I

C blocks supporting both 100kb/s and 400kb/s speed modes.

The key features of the I

C sub-system are:

 Supporting multi-master and slave mode

 7-bit addressing mode only

 Supports serial, 8-bit oriented and bi-directional data transfer

 Supports up to 100 kb/s in the standard mode

 Supports up to 400 kb/s in the fast mode

 Supports master transmit, master receive, slave transmit, and slave receive operation

 Supports both interrupt and polling events

The ADC interface controls one 28nm low power CMOS 1.8V 12-bit ADC. The key features of the ADC sub-system are:

 Up to six channels of analog input can be selected

 Converts analog input into 12-bit binary code up to 1MSPS

 Power consumption 1.0mW when running 1MSPS

 Input frequency up to 100kHz

The ARTIK 530 Module power requirements are managed using a power management integrated circuit (PMIC). This PMIC

device has four fully-integrated fixed-frequency current-mode synchronous PWM step-down converters that can achieve

peak efficiencies of up to 97%. In addition it provides seven low-noise LDOs with currents up to 350mA, one always-on LDO

and an integrated backup battery charger that will provide all power requirements for the ARTIK 530 Module.

The four DC-DC regulators operate at a fixed high frequency of 2.25MHz, minimizing noise in sensitive applications and

allowing the use of small form factor components. These four buck regulators supply up to 3A of output current and can fully

satisfy the power and control requirements of the ARTIK 530 Module. Dynamic Voltage Scaling (DVS) of the various core

voltages is supported using I

C control.

For a detailed description see the section on Power Supply Requirements.

The ARTIK 530 Module has a fully-integrated Wi-Fi

block covering IEEE 802.11 a/b/g/n Wi-Fi

. The most important hardware

features of the Wi-Fi

module are:

 Wi-Fi

802.11 a/b/g/n dual band SISO, 2.4GHz/5GHz compliant

 1T1R 2.4GHz/5GHz band