Datasheet

Registers description LIS3DH
46/54 DocID17530 Rev 2
8.28 INT2_DURATION (37h)
The D[6:0] bits set the minimum duration of the Interrupt 2 event to be recognized. Duration
time steps and maximum values depend on the ODR chosen.
8.29 CLICK_CFG (38h)
Table 69. INT2_DURATION register
0 D6D5D4D3D2D1D0
Table 70. INT2_DURATION description
D[6:0]
Duration value. Default value: 000 0000
1 LSb = 1/ODR
(1)
1. Duration time is measured in N/ODR, where N is the content of the duration register.
Table 71. CLICK_CFG register
-- -- zd zs yd ys xd xs
Table 72. CLICK_CFG description
ZD Enable interrupt double click on Z-axis. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
ZS Enable interrupt single click on Z-axis. Default value: 0
(0: disable interrupt request; 1: enable interrupt request on measured accel. value
higher than preset threshold)
YD Enable interrupt double click on Y-axis. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
YS Enable interrupt single click on Y-axis. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
XD Enable interrupt double click on X-axis. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
XS Enable interrupt single click on X-axis. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)