Datasheet

Registers description LIS3DH
40/54 DocID17530 Rev 2
8.16 OUT_X_L (28h), OUT_X_H (29h)
X-axis acceleration data. The value is expressed as two’s complement left-justified.
Please refer to Section 3.2.1: High-resolution, normal mode, low-power mode.
8.17 OUT_Y_L (2Ah), OUT_Y_H (2Bh)
Y-axis acceleration data. The value is expressed as two’s complement left-justified.
Please refer to Section 3.2.1: High-resolution, normal mode, low-power mode.
8.18 OUT_Z_L (2Ch), OUT_Z_H (2Dh)
Z-axis acceleration data. The value is expressed as two’s complement left-justified.
Please refer to Section 3.2.1: High-resolution, normal mode, low-power mode.
8.19 FIFO_CTRL_REG (2Eh)
Table 48. REFERENCE register
FM1 FM0 TR FTH4 FTH3 FTH2 FTH1 FTH0
Table 49. REFERENCE register description
FM[1:0] FIFO mode selection. Default value: 00 (see Table 50)
TR Trigger selection. Default value: 0
(0: trigger event allows triggering signal on INT1
1: trigger event allows triggering signal on INT2)
FTH[4:0] Default value: 00000
Table 50. FIFO mode configuration
FM1 FM0 Self test mode
0 0 Bypass mode
0 1 FIFO mode
1 0 Stream mode
1 1 Stream-to-FIFO