Datasheet

Working with Bee Modules

This section is about those Bee modules which do not have a MCU pre-programmed with Arduino

bootloader. They mostly act just like a wireless trans-receiver. These Bee Modules like Bluetooth

Bee, etc.. can communicated with PC as well. In this case, Grove - XBee Carrier acts as a carrier

for these Bees providing necessary power, communication interface with PC through FT232RL

USB to UART.

 In the below example Bluetooth Bee is connected to Grove - XBee Carrier and configured

using USB-UART

 The communication of Bluetooth Bee and PC is captured with a serial port terminal application.

 You can see the commands and their reply in the screenshot below.

 The Bluetooth Bee was put into INQ mode and it even has detected a Bluetooth device in the

vicinity.