Datasheet

产品规格书 Product Specification
产品型号 Item.# KS-9C10B060NN-X14 说明 Description Keyboard Switch(青轴) 版本 Version 1
页 码 Page 第3 页 3 of 8 日期 Date
2016-05-25
5.1
总行程
Total travel
4.0+0/-0.4mm
按键轴沿操作方向从初始位置到最大行程位置时的距离
The Actuator hall be reduced to the tip of actuator
in operating direction to change component from
operating position to end point
5.2
动作行程
Output resolution
2.3±0.6 mm
按键轴沿操作方向从初始位置到按键开关动作位置时的
距离
The Actuator shall be applied to the tip of actuator
in operating direction to change the component to
operating positio
5.3
操作力
Operating Force
60±15gf
在操作元件末端沿操作方向均匀施加静载荷，使操作元件
转换到动作位置
A static load shall be applied to the tip of actuator
in operating direction to change the component to
operating position
5.4
全行程压力
End force
＜110gf
按键轴沿操作方向从初始位置到最大行程位置时的动作
力
The Actuator hall be reduced to the tip of actuator
in operating direction to change component from
operating position to end point
5.5 振动试验
Vibration
实验后 After test:
- 电气性能应符合第 4.1～
4.4 项要求
- Electrical
characteristics of items
4.1 ～ 4.4 shall
be satisfied.
- 机械性能应符合 5.1～
5.4 项要求
- Mechanical
characteristics of items
5.1 ～ 5.4 shall
be satisfied.
按键开关按常规的安装方法牢固地安装在试验设备上，并
在下述参数条件下进行试验(10 个一组):
Key Switch be secured to a testing machine by a
normal mounting device and method. Switch shall be
measured after following test(10 pcs of group).：
1. 振频(Vibration frequency range) = 10-22.5 Hz
振幅(Total amplitude) = 0.25mm
振动变化速率(Sweep ratio)：10-55-10Hz
2. 振频(Vibration frequency range) = 10-16 Hz
振幅(Total amplitude) = 3mm
振动变化速率(Sweep ratio)：10-55-10Hz
5.6
冲击试验
Shock
试件在下述参数条件下进 行试验：
(Switch shall be measured after following test:)
(1) 安装方法：常规方法( Mounting Method: Normal )
(2) 加速度(Acceleration) : 245m/s2 (25G)
(3) 时间( Duration ) : 11ms
(4) 实验方向：图示 6 方向(Test Direction : 6
directions)
(5) 冲击次数：每个方向 3 次 (总共 18 次)
Number of shocks : 3 times per direction (18 times
in total)