Datasheet

产品规格书 Product Specification
产品型号 Item.# KS-9C10B060NN-X14 说明 Description Keyboard Switch(青轴) 版本 Version 1
页 码 Page 第2 页 2 of 8 日期 Date
2016-05-25
1. 一般特性
General Characteristics:
2. 外观，结构及尺寸
Appearance, Structure and Dimensions:
2.1 外观
Appearance
产品外观良好，无锈蚀、裂纹和镀层缺陷。
The switch shall have good finishing, and no rust, crack or plating
defects.
2.2 结构及尺寸
Structure and Dimensions
参见产品图纸
Refer to individual product drawing
2.3 标识
Markings
参见产品图纸。
Refer to individual product drawing.
3. 额定负荷 Ratings:
额定负荷 Ratings Rotational：10mA 12VDC (Resistance load)
4. 电气性能 Electrical Characteristics:
项目Item 标准Criteria 实验方法 Test Method
4.1
绝缘电阻
Insulation Resistance
100MΩ Min.
在相互绝缘的所有端子之间及各接线端子与外露的非载流金属零
件之间加载
100V 直流电，持续时间 60 ± 5 秒。
100V DC voltage is applied between each pair of terminals, and
between the terminal and the metal frame for 60 ± 5 Sec.
4.2
接触电阻
Contact resistance
200 mΩ Max
(Typical：25 mΩ）
以 1mA 5V 直流电，采用点对点测量；也可用误差不超过 5%的仪表
进行测量，试验后的电阻取 4 次测量的平均值。
Measured by contact-to- contact method at 1mA Max,5VDC,Any
equipment with error not more than 5% can be used Resistance
after test is the average of 4 successive measurements.
4.3
抗电强度
Dielectric Voltage
无击穿现象发生
No dielectric
breakdown shall
occur
在相互绝缘的所有接线端子之间及各接线端子与外壳或非载流金
属零件之间加载 100V(50-60Hz，泄漏电流 2mA )交流电，持续时间
60±5 秒。
100V(50-60HZ,cut –off current 2mA )alternate current load
is applied between open terminals and between terminals and
the metal frame or between metal parts, for 60 ± 5 Sec.
5. 机械性能 Mechanical Characteristics:
项目
Item 标准Criteria 实验方法 Test Method
1.1 适用范围
Application
该规格书指开关的一般使用范围
This specification is applied to the switch for general applications.
1.2 使用温度范围
Operating Temperature Range
-40°C 到 +80°C
-40°C to +80°C
1.3 使用相对湿度范围
Operating Relative Humidity Range
≦85% RH, +40° C
1.4 实验条件
Test Conditions
若没有特别说明，则试验大气条件如下：
Unless otherwise specified, the atmospheric conditions for making
measurements and tests are as follows:
环境温度 Ambient Temperature: 5-35°C
大气压力 Air Pressure: 86-106 Kpa
相对湿度 Relative Humidity: 45-85% RH