Datasheet

NEO-6 - Data Sheet
GPS.G6-HW-09005-E Page 22 of 25
7 Default settings
Interface
Settings
Serial Port 1 Output
9600 Baud, 8 bits, no parity bit, 1 stop bit
Configured to transmit both NMEA and UBX protocols, but only following NMEA and no
UBX messages have been activated at start-up:
GGA, GLL, GSA, GSV, RMC, VTG, TXT
(In addition to the 6 standard NMEA messages the NEO-6T includes ZDA).
USB Output
Configured to transmit both NMEA and UBX protocols, but only following NMEA and no
UBX messages have been activated at start-up:
GGA, GLL, GSA, GSV, RMC, VTG, TXT
(In addition to the 6 standard NMEA messages the NEO-6T includes ZDA).
USB Power Mode: Bus-Powered
Serial Port 1 Input
9600 Baud, 8 bits, no parity bit, 1 stop bit
Automatically accepts following protocols without need of explicit configuration:
UBX, NMEA
The GPS receiver supports interleaved UBX and NMEA messages.
USB Input
Automatically accepts following protocols without need of explicit configuration:
UBX, NMEA
The GPS receiver supports interleaved UBX and NMEA messages.
USB Power Mode: Bus-Powered
TIMEPULSE
(1Hz Nav)
1 pulse per second, synchronized at rising edge, pulse length 100ms
Power Mode
Maximum Performance mode
AssistNow
Autonomous
Disabled.
Table 15: Default settings
Refer to the u-blox 6 Receiver Description including Protocol Specification [2] for information about further
settings.