Datasheet

3. Demonstration

3.1 Hardware installation

1. Connect the Grove socket marked "IN" on the LED Strip Driver and digital port 2 on the Base

Shield with a Grove cable.

2. Connect the LED strip to the 4 pin terminal of Grove - LED Strip Driver. Make sure the wire

marked "+12v" of the LED strip goes into the seat marked "+" of the terminal,

and "B" into "B","R" into "R" and "G" into "G". Most of the LED strips we are selling have

4 wires as the picture above except White LED Flexi-Strip - 60 LED - 1m. If this is the kind you

are going to use, the connection steps can be a little different. Still plug the wire

marked "+12V" into the seat marked "+", but the other wire can go into whichever seat

of "B", "R" and "G". And run the demo code named "DemoForWhiteLEDStrip" instead in

the following software steps.