Datasheet

WS2813-Mini

Intelligent control LED

integrated light source

http://www.world-semi.com

 Reflow instruction

1. No more than two times of reflow.

2. Do not beat the colloid surface when the material is heated.

 Manual Soldering instruction

1. Soldering iron’s temperature must be under 300℃, and operating time must be less than 3 seconds.

2. It should be done only once for the manual soldering.

 Repairing instruction

Normally, it can’t be repaired after reflow. You need to use double-ended solder iron and make sure that whether it will

do damage to the LEDs’ characteristics when repairing is inevitable.

 Storing and Transporting

1．Scope of application

Front side up, moisture-proof and waterproof, no extrusion, no collision and no vibration.

2．Storage and its period

1 Room temperature sealed storage: 20℃～30℃, 40%～60%RH, product is valid for ONE week.

2 Moisture-proof sealed storage: 20℃～30℃, 25%～60%RH, product is valid for TWO weeks.

3 Use up with 2 hours after removing from packages.(Environmental conditions for temperature <30℃,

relative humidity<60%)

 Dehumidification

We would recommend to do dehumidification if they exceed the valid storage period of products or dampened due to

other reasons.

Dehumidification Method: 70℃-75℃/48±2 Hours

 Electrostatic Protection

LED is an electrostatic sensitive component, although the LED products are with excellent anti-static ability, they will

cause a certain damage by any electrostatic discharge. By taking some electrostatic measures to avoid the damages when

using the LEDs, such as wearing anti-static gloves and anti-static bracelet, etc..