Datasheet

晶汉达 · JHD
MODEL: JHD1804
Note that the presence of
waterdrops or dew in the
LCD panel may deteriorate
the polarizer or corrade
electrode.
Don’t Drop Water on LCD!
Precaution in Soldering LCD Module
Basic instructions: Solder I/O terminals only.
Use soldering iron without leakage.
(1)Soldering condition to I/O terminals
Temperature at tip of the iron: 280±10℃
Soldering time: 3~4 sec.
Type of solder: Eutectic solder (containing colophony-flux)
*
Please do not use flux because it may soak into LCD Module or contaminate it
Please
do
not
use
flux
because
it
may
soak
into
LCD
Module
or
contaminate
it
.
*It is preferable to peel off protective film on display surface after soldering I/O
terminals is finished.
(2)Remove connector or cable
*When you remove connector or cable soldered to I/O terminals, please confirm
that solder is fully melted. If you remove by force, electrodes at I/O terminals may
be damaged(or stripped off).
*It is recommended to use solder suction machine.
Long-term Storage
If it is necessary to store LCD modules for a long time, please comply with the
following procedures
following
procedures
.
If storage condition is not satisfactory, display(especially polarizer) may be deteriorated
or soldering I/O terminals may become difficult(some oxide is generated at I/O
terminals plating).
1.Store as delivered by Optrex
2.If you store as unpacked,put in anti-static bag,seal its opening and store where it is
not subjected to direct sunshine nor fluorescent lamp.
3 Store at temperature 0 to +35
℃
and at low humidity Please refer to our specification
3
.
Store
at
temperature
0
to
+35
℃
and
at
low
humidity
.
Please
refer
to
our
specification
sheets for storage temperature range and humidity condition.
Long-term Storage
Please use power supply with built-in surge protection circuit.
HTTP://WWW.JHDLCD.COM.CN
22Page: