Datasheet

Bosch Sensortec
| BMI088 Data sheet
2 |
48
Modifications reserved | Data subject to change without notice
Document number: BST-BMI088-DS001-1
3
Revision_1.3_05201
8
Basic Description
BMI088 is an inertial measurement unit (IMU) for the detection of movements and rotations in 6 degrees
of freedom (6DoF). It combines the functionality of two inertial sensors in one device: an advanced
triaxial 16-bit gyroscope and a versatile, leading-edge triaxial 16-bit accelerometer.
BMI088 is designed to meet all requirements for high performance consumer applications in harsh
vibration environments such as those encountered in drones and robotics applications. The IMU is
designed to effectively suppress vibrations above a few hundred Hz that could occasionally occur due
to resonances on the pcb or the structure of the total system.
The sensor has an extended measurement range of up to ±24g to avoid signal clipping under strong
signal exposure.
An evaluation circuitry (ASIC) converts the output of the micro-electro-mechanical sensing structures
(MEMS), which are developed, produced and tested in BOSCH facilities. The corresponding chip-sets
are packed into one single LGA 3.0mm x 4.5mm x 0.95mm housing. For optimum system integration,
BMI088 is fitted with digital interfaces (SPI or I2C), offering a wide VDDIO voltage range from 1.2V to
3.6V. To provide maximum performance and reliability, each device is tested and is ready-to-use
calibrated.
To increase flexibility, both gyroscope and accelerometer can not only be operated individually, but tied
together for data synchronization purposes. The on-chip features comprise FIFOs for acceleration and
gyroscope data and interrupt controllers.
The BMI08x has an excellent temperature behavior with an outstanding low temperature coefficient of
the offset (TCO) and temperature coefficient of the sensitivity (TCS).