Datasheet

Preliminary Data Sheet
BMA400
Page 50 /
Confidential
BST-BMA400-DS000-00 | Version 0.1 | November 2017 Bosch Sensortec
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying and passing on to third parties.
BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
Interrupt engine overrun
The interrupt overrun ishall be asserted if filter and interrupt computations cannot be finished in a
sample acquisition time. The interrupt status is mapped (mirrored) to all interrupt registers INT_STAT0,
INT_STAT1 and INT_STAT2, bit ieng_overrun_stat. The interrupt is cleared by reading of any of these
registers.
The interrupt is mapped to pads INT1 and INT2 by the registers INT1_MAP.
ieng_overrun_int1 and INT2_MAP. ieng_overrun_int2.
The interrupt behavior is not dependent on non-latch, latch mode setting.
Confidential and under NDA
Seeed Studio
Confidential and under NDA
Seeed Studio
Confidential and under NDA