Owner manual

SEED HAWK

2015 TOOLBAR OPERATOR’S MANUAL

5.0 SBR

Hitch Toolbar

(Loup III & SCT

)

5.1 Requirements

5.2 Operation

NOTE: Before operation of the SBR, make sure the Toolbar is folded

down in the working position.

1. Lower the SBR arm into eld working position by removing locking pin. The

SBR must be in the down position to function properly.

2. Adjust paddle height by using the adjustment bolt at the top of the SBR arm

shown in, so paddle will run between the stubble rows.

3. During eld operation turn the SBR switch to On/Auto

Refer to Section 4.4 pertaining to the control system being used.

4. When SBR is not in use, turn the SBR switch to Centering.

• On SCT

switch box, Off is centering.

• On Loup III monitor switch box, use the Centering switch to center the

SBR hitch, turn switch to Off.

5. Lift the SBR arm into lock position and insert locking pin.

• Field must be seeded with GPS auto-steer and same row spacing the year

before.

• Must seed in exactly the same direction as the previous year.

• The sensing arm must follow between the two rows of stubble 4”-6” above

the ground.

SBR Adjustment Bolt

Locking Pin