User Manual

SEEDHAWK®TOOLBAROPERATOR’SMANUAL59
8.3.1 NODELIGHTDEFINITION
LogicPower:Lightsupsolidwhen12VispresentforLogicPower.

HCPower:Lightsupsoildwhen12VispresentforHighCurrentPower.

Micro1Hz:Flashesoncepersecondifprocessorisworkingcorrectly.

CANRx:FlashesintermittenlywhenCANcommunicationispresentgoingTOthenode.

CAN Tx: Flashes intermittently when CAN communication is present going AWAY from the
node.

Diagnostic1Light:
Aircart Node: When solid; indicates that at least one of the active products is not yet
calibrated;e.gmissingcalrate,metercalorvalvecal.

Diagnostic2Light:
AircartNode:

DiagnosingNodeLights

CANRx/Tx:OFF‐noCANcommunication
CANRx/Tx:ON‐partialCANcommunication,possiblebreakinCANhi/loorpoorconnection.
Micro1Hz:ON‐Nodelockedup,spikeordropinvoltage
Micro1Hz:OFF‐thereisnologicpower,ifthereislogicpowerthennodeisbadorlogicpower
isoutofrange(under10V),verifylogicpowerintonodeandchecksourceoflogicpower.