User Manual

SEEDHAWK®TOOLBAROPERATOR’SMANUAL49
6.0 SBR®  HITCH  TOOLBAR  ONLY,  LOUP  III  &  SCT

6.1 REQUIREMENTS

1.FieldmustbeseededwithG.P.S.autosteerandsamerowspacingtheyearbefore.
2.Mustseedinexactlythesamedirectionasthepreviousyear.
3.Thesensingarmmustfollowbetweenthetworowsofstubble4”‐6”abovetheground.

6.2 OPERATION

NOTE:BEFORE OPERATION OF THE SBR, MAKE SURE THE TOOLBAR IS FOLDED DOWN IN
WORKINGPOSITION.

1.LowertheSBRarmintofieldworkingpositionbyremovinglockingpinshowninFIGURE28.
TheSBRmustbeinthedownpositiontofunctionproperly.
2.Adjust paddle height by using the adjustment bolt at the top of the SBR arm shown in
FIGURE28,sopaddlewillrunbetweenthestubblerows.
3.Infield operationturnthe SBR switch to ON/AUTO.REFER TO SECTION 4.5,pertainingto
thecontrolsystembeingused.

4.When SBR is not in use, turn the SBR switch to CENTERING.On SCT switch boxes OFF is
centering.On LOUP III monitor switch boxes use the CENTERING switch to center the SBR
hitch,turnswitchtoOFF.REFERTOSECTION4.5,pertainingtothecontrolsystembeingused.

5.Lift the SBR arm into lock position and
insertlockingpin,FIGURE28.






Lockpinlocation
SBRad
j
ustmentbolt
FIGURE28