User Manual
SEEDHAWK®TOOLBAROPERATOR’SMANUAL35
4.Movingina forwarddirection,turn“MASTER”switchtotheonposition,thiswillengagethe
openershanks.NotesectionswitchesmustbeinSCT®inorderforSectionalcontrol®towork.
REFERTOSECTION4.5,pertainingtothecontrolsystembeingused.
5.Manually adjusting the packing pressure can be done by increasing or decreasing the
packingpressureswitchontheswitchbox.
NOTE: In order to get the proper packing and penetrating forces per field, we recommend
lowering the opener shank pressure from the tractor at the beginning of each field.Every
new Seed Hawk toolbar manufactured leaves with the opener shank pressure set at
approximately1000PSI.Thechain between theseed and fertilizerknifewillbetightwhen
applying the proper amount of pressure to the opener shank.Once the knives get tight,
notice the shank pressure gauge and the reading.In good seeding conditions, add an
additional 200 PSI to the system.When seeding small seeds such as CANOLA in wet
conditions, adding an additional 200 PSI is not recommended.This would cause over
compaction.Maxpackingpressureis1500PSI.
6.Tomanuallydisengagingtheopenershanks,turn“MASTER”switchtotheoffposition.The
operatormust be driving over previously seeded area to automaticallydisengage the opener
shanksusingsectionalcontrol.REFERTOSECTION4.5,pertainingtothecontrolsystembeing
used.
NOTE: ALWAYS ENSURE THAT THE OPENER SHANK IS MAINTAINING SEED AND FERTILIZER
SEPERATION.SEEDHAWKINC.RECOMMENDSCHECKINGTHEACTUALSEEDANDFERTILIZER
SEPERATON IN EACH FIELD.SOILS VARY, MOISTURE CONDITIONS VARY.OVER TIME THE
OPENERBOLTS IFNOTTIGHTENEDONAYEARLYBASISWILLFUNCTIONDIFFERENTLYFROM
THENEWMACHINE,SEEDANDFERTILIZERSEPERATIONMAYCHANGE.
4.10 WINGINGUPTOOLBAR
1.Makesureallopenershanksareup.
2.Reversetheleverdirectionin thetractorcabthattheGREENbandedhosesarehooked,this
willallowthewingstofoldupintotransportposition.
NOTE:MAKESURETOLOCK THEBALLVALVESONBACKOFOPENERHYDRAULICBLOCK.ON
SCT®TOOLBARSTHEBALLVALVESARELOCATEDONTHEMAINBRIDLE.
THISGAUGEWILLREAD
PRESSUREWHENWINGINGUP