User Manual

SEEDHAWK®TOOLBAROPERATOR’SMANUAL31
4.6 WINGINGDOWN7‐PLEXTOOLBARS
NOTE:Please ensure your case drainYELLOW banded hose(s)are connected to the tractor
circuitwhichis plumbeddirectlytothe reservoirfirst.Ifthecontrolbox hasa7‐plexwing
downbuttonpleaseusethefollowing2stepstolowerthewingssafely.Ensurecontrolboxis
poweredupwith12v.Ensurethecasedrain(s)gaugeonhydraulicblock neverexceeds100
PSI,excessiveamountsofpressurewilldamagethegauge.

1. Engage the lever in the tractor cab that the GREEN banded hoses are hooked to (which
lowersyourmainwings),pressand  holdthe“WINGDOWN” switch untilall wingsare onthe
ground.Alsousedfor50’ &60’45series toolbars.REFERTOSECTION4.5, pertainingtothe
controlsystembeingused.

2.Release switch and leave the lever (that your GREEN banded hoses are hooked to) in
workingposition“NOTFLOAT”.

4.7 OPENERSHANKOPERATION–TOOLBARONLY

1. Ensure that there is power going to the Seed Hawk switch control box.Ensure that balls
valuesonthebackofopenerhydraulicmanifoldareopen.

2.EngagethetractorhydraulicsleverthattheRED bandhose(openercircuit)areconnected
to.

3.LockthetractorhydraulicsleverthattheGREENbandedhoses(wingcircuit)areconnected
to.The full  tractor pressure is shown on the top right (4000 PSI gauge) of  the hydraulic
manifoldblock.












4.Movingina  forwarddirection,turnonthe“PWMDOWNPRESSURE” switch, thenturnon
the “SHANK /LIQUID PUMP” switch on.
This will en gage the opener shanks.REFER TO
SECTION4.5,pertainingtothecontrolsystembeingused.
FULLTRACTOR
PRESSURE