User Manual
SEED HAWK
®
2014 LOUP III & VIPER PRO™ HYDRAULIC DRIVE CALIBRATION GUIDE 25
Press the INC button to increase the PWM Out-
put (this will increase the speed of the roller)
Use the INC and DEC buttons to achieve the de-
sired roller rpm. It is important to calibrate as close
to the actual seeding rpm of the roller. Refer to the
Meter RPM charts (pg. 31-33) to get an approx-
imate rpm the roller will be turning during seeding.
based on the specic roller and drill width.
Once the meter is primed (at least two revolutions)
select STOP. Empty the product caught and reposi-
tion the calibration bucket under the meter
Continue to next page