Owner manual

Seed Hawk Manual Granular and Liquid Tanks Page 52



9.6 METER SETTINGS

9.6.1 Meter Selection

Select which Meter you would like to view or make changes to.



Note: All Meters on a machine must be individually calibrated. Calibrations

must be done each time a crop is changed.



9.6.2 Pulses Per Rev

This is the number of pulses produced by

the meter sensor in one revolution. The

default setting is 80. If using a setup other

than a standard Seed Hawk configuration

this setting may need to be changed. To

change this setting use the up/down arrow

keys to highlight the line “Pulses Per Rev

80” and press the select button. “80” will

now be highlighted and can be changed

using the up/down arrow keys. Once the

desired value is on the screen press the

SELECT button again and the highlight bar

will move to the “Low Alarm Point” bar.

