Owner's manual

SEED HAWK

2015 AIRCART OPERATOR’S MANUAL

1. After turning on the remote calibration console, the bin selection screen is

displayed. Using the Soft Keys select the bin which corresponds to meter to be

calibrated and select "ENTER" using the white Soft Keys.

2. Press the Soft Key labeled "BEGIN" to start the calibration process.

3. The meter needs to be primed before calibration begins to ensure full prod-

uct ow during calibration. Select "PRIME METER ROLLER" to prime the meter

and press the Soft Key labeled "ENTER."

NOTE: It is important to cal-

ibrate as close to the actual

seeding rpm of the roller as

possible. Refer to Section 8.4

for the Meter RPM Chart,

to get an approximate roller

rpm for the specic roller

and drill width.