Owner's manual

SEED HAWK

2015 AIRCART OPERATOR’S MANUAL22

4.2.2 Labeled Lodar Receiver Diagram

LED marked “SET”

indicates system is active.

LED marked “5V” Indicates power

supply for control circuits is OK.

LED’s marked “F1-F2-F3-F4-F5-F6 and M” When ON

indicate an output to that function.

LED marked “FAULT” Indicates an overload is

present; the System cannot be RESET until overload

is removed. This LED blinks for 20 seconds when the

Receiver is initially powered. A replacement Transmitter

has to be registered during this 20 second period.

Voltage

Working Range: 12 Volts to 36 Volts DC.

Limits: 8 Volts minimum to 40 Volts absolute max.

NOTE: 42 Volt System (48 Volt Max is currently Special Order.)