Owner's manual

SEEDHAWK
®AIRCARTOPERATOR’SMANUAL59
7.3.9 REMOVEALLSENSORS
This menu item is used when installingapreviouslyusedmonitoron anewsystem. Selecting
this item will clear the monitor’s memory of all learned sensors. This selection cannot be
undone. This selection does not affect CAN based sensors (meters and down pressure), only
MUXbasedsensors(groundspeed,fanspeed,binlevel).


7.4 ALARMS
Thealarmdisplaywillbecomeactivewhenanyconditionsfallbeloworriseabovethesetalarm
point. For example: Low Bin level, No Ground Speed, Low or High  Fan Speed and Low Meter
Speed are all alarm conditions. All alarms operate in a similar fashion: An audible alarm will
sound and an alarm message will appear on the display instructing you to press the soft key
labeledF1toacknowledgethealarm.

Onceacknowledged,theaudiblealarmwillceaseand aniconofabell atthetopofthedisplay
willflash.Also,aniconassociatedwiththespecific
alarmwillblink. Forexampleifthebinlevel
alarm forbin#1becomesactive and is acknowledged,theBin 1 icon willflash alongwith the
alarmbellicon.Ifbin2thenshowsanalarmconditionthentheaudiblealarmwillsoundagain.
Onceacknowledged,thebin1andbin2iconswillflashalongwiththealarmbellicon.

LowandHighfanspeedalarmscan’tbeacknowledged.Thealarmconditionmustbecorrected
toclearthescreenofthealarmwarningandtoquiettheaudiblealarm.Ifthisalarmisgoingoff
inerror,checkthe
highandlowalarmpointsettingsbygoingtothesen sorconfigurationmenu,
highlightingthesensorinquestionandpressingthe“Settings”softkey.
