Owner's manual

SEEDHAWK
®AIRCARTOPERATOR’SMANUAL57
7.3.6 CLEARFIELDACRES
Choosing this item allows you to clear the accumulated field  acres. A dialog box will appear
verifyingyourselection.Onceverif iedthefieldacrescannotberestored.
NOTE:Total acres cannot be cleared from the settings menu. Contact your SeedhawkDealer
forinformationonclearingthetotalacresregister.

7.3.7 RATECONTROLLERMETERSETUP
Thisselectionallowstheoperatortoentersetup
informationforthemeters.Thedefaultscreenis
meter 1. Other meters can be selected by
pressingthesoftkeyforthedesiredmeter.

1. Pulses per Rev: This is the number of pulses
generated by the meter sensor equal to 1
revolution of the meter roller. This value is set
by default but can be manually entered. The
default value for a hydraulic drive system is
60.31.

2.Lowalarmpoint:Thisistheminimummeterrpmspeedthemetercanturnbeforethe“low
meterrpm”or“meterstopped”alarmswilldisplay.Thedefaultvalueis0.5RPM.

3. Weight/Rev: This value is determined by the Meter calibration procedure or it can be
manuallyentered.

4.Increment:Thisvalueistheincrementvalueforonthegorateadjustmentswhenseeding.
Thedefaultvalueis5.00lb/ac.
5. OK/Cancel: Select
 “OK” to save any changes made. Select “Cancel” to ignore any changes
made.
