Owner's manual

SEEDHAWK
®AIRCARTOPERATOR’SMANUAL44
5. Meter Calibration: This is used to perform
stationary meter calibration tests and enter
accuratemetercalibrationinformation.
6. Clear Field Acres: Used to clear the field acre
register.

NOTE:Thetotalacres cannot beclearedfromthe
Menu Settings screen. To clear the Total Acres a
USBdrive with aprogram to clear theacresmust
beused
7, 8, 9. These menu items are for use with Loup Electronics blockage monitoring and do not
currentlyapplytotheSeedHawkmonitor.
10. Rate Controller Meter Setup: This menu
choice displays the application rate per meter
revolution determined by the individual meter
calibrations and allows you to enter different
valuesdirectlyifdesired.Thisscreeniswherethe
pulses per revolution of the meter rotation
sensor can be entered if a value different than
the factory configuration is needed and the
increment rate for on the go application rate
changes is enteredforeach meter.This screen is
alsowherethelowmeterRPMalarmpointisset.

Thereisascreenavailableunderthischoiceforeachinstalledmeter.Usethesoftkeytoselect
the
 meter settings you want to review and adjust. Four meters are shown but meters not
installedcannotbeaccessed.
