Owner's manual

SEEDHAWK
®AIRCARTOPERATOR’SMANUAL43
TheMenuSettingsscreenlists12choices:

1. MuxBus Sensor Setup: This is used to install and remove sensors that operate on the
MuxBus network. These include the ground speed sensor, the Fan sensors, the Bin Level
sensors,pressureandflowsensors.

NOTE:TheVARControllerlistedisnotusedinthisapplication

NOTE:ThepressuresensorlistedasaMuxBussensorisavailablebutadifferentsensorthan
thePacking Pressure sensor.Thatsensoris connected to the hydraulicdrive controlmodule
andiscommunicated ontheCANnetwork.ItiscalledShankPressureinthelayoutitemselect
menu.
2. Global Settings: Use this menu selection to
set the units of measure, language, implement
width, the volume of  the alarm, the backlight
and contrast of the screen, and the master
switchmode



3.RestoreSettingstoDefaults:Thisisusedto
returnallsettingstofactorydefaults.(Warning?)




4. Ground Speed Calibration: This is used to
perform a field calibration for accurate ground
speed input. The accuracy of this calibration
affectsapplicationrates,acreaccumulation,and
groundspeed.