Owner's manual

SEEDHAWK®AIRCARTOPERATOR’SMANUAL16
4.1.3 PAIRINGTHEREMOTE

The remote should arrive ready forthecustomer to use, but if it becomesunpairedfrom the
receiverorareplacementremoteispurchased,itisnecessarytoregistertheremotewiththe
receiver.

1. Switch OFF or DISCONNECT the power to
the receiver.

2. Switch ON or reconnect the power to the
receiver. This opens a 20 second
registration window in the receiver. If you
arelookingatthereceivercircuitboard,the
faultLEDflashes.

3. Immediately PRESS and HOLD the
transmitter green buttonfor a minimumof
10 seconds during this 20 second window.
WhentheTransmitteris registeredthefault
LED goes out, and the set LED comes on.

4. Thetransmittercannowcommunicatewith
the receiver, and a light on the receiver
flashes with each button press on the
transmitter.
