User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL91
4.29 SUPPLYANDDROPTUBES

4.29.1 BASICCONFIGURATION

Productis delivered to the knife through a supply tube. The supply
tube slides into a formed rubber drop tube, #1 FIGURE 4.125.The
formed rubber drop tube is attached to the knife by sliding tab, #2
FIGURE4.125intotheslotontheopenershank.

As the formed rubber
 drop tube wears, it  can be trimmed and
repositioned.Alldrop tubesshould bepositioned so the tip of the
droptubeis0.5in(13mm)belowthestainlesssteelclip.Alwayscut
droptubeonanangletoallowairtoflowandescape.

























The seed pipes are connected to the seed boots(A). The seed boots are clamped to thedrill
coultersbystainlesssteeltineshields(B).

Astheseedbootswear,theycanbemoveddownwards.Cutoffwornmaterialwithahacksaw.
All the seed boots must be installed so that the distance
 between the seed boots and the
stainlesssteeltineshieldsisabout13mm.SEEFIGURE4.126.
1
2
FIGURE4.126 
FIGURE4.125 