User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL77
4.24.7 TRAMLINESETUP
The Tramline function must be enabled to be used. Also, Tramline control valves must be
connectedtothesystemharnessforthemonitortoshowanyoperationfunction.

1.Toenable the tramlineoperation, pressanyof the soft
keys to bring up the sof t key menu. Then press the
“Tramline” button. Press “Enter” again to bring up the
Enable/Disablemenu.







2.Navigate to “Enable” and press “Enter”.Navigate to
“Sprayer Boom Width” and press “Enter”. A drop down
keypad will appear so the user will be able to enter the
widthofthesprayer.







NOTE:The sprayer boom width must  be a multiple of the Seeding passwidth. If the Seeding
pass width is 30ft (9m) the sprayer boom width must be 30ft (9m), 60ft (18m), 90ft (27m),
120ft (35.58m) etc.The seeding pass width is the same as the implement width entered in
Globalsettingsandshouldnotneedtobechangedasiscarriesinfromtheglob alsettingentry.

Itcannot beaccessedfromthisscreen.Iftheusermakeschangestothesesettings,cyclethe
poweronthemonitortoresetallthevaluesinthepermanentmemory.


3.“Start First Field Pass” resets the register to pass # 1
when it is set to “YES”. To change
 this setting navigate to
this menu choice and press “Enter” then highlight the
choice you want and press “Enter”. This menu selection
should normally be set  to “NO” so the pass register does
notresetwhenyouaccessthisscreen.
FIGURE4.96
FIGURE4.95
FIGURE4.94