User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL70
4.22.7 REMOVEALLSENSORS
This menu item is usedwhen installinga previouslyusedmonitoron anew system. Selecting
this item will clear the monitor’s memory of all learned sensors. This selection cannot be
undone. This selection does not affect CAN  based sensors (meters and down pressure), only
MUXbasedsensors(groundspeed,fanspeed,binlevel).

4.23 ALARMS
Thealarmdisplaywillbecomeactivewhenanyconditionsfallbeloworriseabovethesetalarm
point. For example: Low Bin level, No Ground Speed, Low or High Fan Speed and Low Meter
Speed are all  alarm conditions. All alarms operate in a similar fashion: An audible alarm will
sound and an alarm message will appear on the display instructing the user to press the soft
keylabeledF1toacknowledgethealarm.

Onceacknowledged,theaudiblealarmwillceaseandaniconofabellatthetopofthedisplay
willflash.Also,aniconassociatedwiththespecificalarmwillblink.Forexampleifthebinlevel
alarmforbin #1 becomesactive andis acknowledged,theBin1 icon will flashalong withthe
alarmbellicon.Ifbin2thenshowsanalarmconditionthentheaudiblealarmwillsoundagain.
Onceacknowledged,thebin
1andbin2iconswillflashalongwiththealarmbellicon.

Lowand Highfanspeedalarmscan’tbeacknowledged.Thealarmconditionmustbecorrected
toclearthescreenofthealarmwarningandtoquiettheaudiblealarm.Ifthisalarmisgoingoff
in error, check
 the high and low alarm point settings by going to the sensor configuration
menu,highlightingthesensorinquestionandpressingthe“Settings”softkey.
FIGURE4.79 