User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL68
4.22.4 CLEARFIELDACRES
Choosing this item allows the user to clear the accumulated field acres.A dialog box will
appearverifyingtheselection.Onceverifiedthefieldacrescannotberestored.

NOTE:Total acres cannot be cleared fromthe settings menu. Contact your SeedhawkDealer
forinformationonclearingthetotalacresregister.

4.22.5 RATECONTROLLERMETERSETUP
This selection allows the operator to enter setup
informationfor the meters. The default screen is
meter1.Othermeterscanbeselectedbypressing
thesoftkeyforthedesiredmeter.

1. Pulses per Rev: This is the number of pulses
generated by the meter sensor equal to 1
revolutionofthemeterroller.Thisvalueissetby
defaultbutcan be manuallyentered.Thedefault
valueforaFenix2is10.00pulses/rev.

2.Lowalarmpoint:Thisistheminimummeterrpmspeedthemetercanturnbeforethe“low
meterrpm”or“meterstopped”alarms
willdisplay.Thedefaultvalueis0.5RPM.

3. Weight/Rev: This value  is determined by the Meter calibration procedure or it can be
manuallyentered.

4.Increment:Thisvalueistheincrementvalueforonthegorateadjustmentswhenseeding.
Thedefaultvalueis5.00lb/ac.

5. OK/Cancel: Select “OK” to save any changes made. Select “Cancel” to ignore any change s
made.
FIGURE4.74 
FIGURE4.75