User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL59

6. Ignore/Revive: The user can temporarily
disable sensors by placing the highlight bar on
the desired sensor selecting Ignore. Re‐enable
that sensor by placing the highlight bar on  the
sensor and selecting Revive. This is used to
disable a sensor if a part of the system is not
being used such as a bin that is left empty. By
ignoringthe sensoryouwilleliminateunwanted
alarms.
4.19 GLOBALSETTINGS
Use this menu selection to set the units of
measure, language, implement width, the
volume of the alarm, the backlight and contrast
of the screen, and the master switch mode. To
access the Global Settings from the run screen
pressanysoftkeytobringupthesoftkeymenu
andpress“Setup”.Navigatethehighlightbarto
the “Global Settings” selection and press
“Enter”.



Atthisscreentheusercan reviewthebasic systemsetupandmakechangesasnecessary. To
make changes, navigate the highlight box to the item wishing to adjust and press “Enter”. A
drop
down box will appear and show the choices.Navigate to the choice wanted and press
enter.


1. Units: Available choices are Metric, Imperial,
and US Imperial. Navigate to the selection you
wantandpress“Enter”.
FIGURE4.52
FIGURE4.51
FIGURE4.50