User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL57
12. Remove all sensors:This menu choice allows
the user to quickly unlearn all MuxBus sensors
installedon the syst em. This is anecessary step if
it becomes ne cessary to relearn the MuxBus
systemonamonitorthatsensorsinstalled.





4.18.1 MUXBUSSENSORSETTINGSANDINSTALLATION
At the “MenuSettings”screen usethe navigationkeys orthe spinnerdialplace the highlight
bar on item 1 “MuxBus Sensor Setup”. Select this item by pressing the spinner dial or the
“Enter”key.

1.Newsysteminstallation:Placethehighlightbaron“AutoDetect”.Press“Install”.
2.Pluginthesensors:intheorderlistedonthemenu.Differentsensorshavedifferenttypes
andcannotbelearnedtothewronglocationbutthefirstfansensorpluggedinwillbeassigned
toFan1.ThefirstBinLevelsen sorpluggedinwillbelearnedtoBin
1,etc.Thespeed,pressure,
andflowsensorsallusethesametypesensorcodesothefirstonepluggedinwillbethespeed
sensor,etc.

FIGURE4.45
FIGURE4.46
