User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL56
6. Clear Field Acres: Used to clear the field acre
register.

NOTE:Thetotalacrescannotbeclearedfromthe
Menu Settings screen. To clear the Total Acres a
USBdrivewithaprogramtocleartheacresmust
beused
7, 8, 9. These menu items are for use with Loup Electronics blockage monitoring and do not
currentlyapplytotheSeedHawkmonitor.
10. Rate Controller Meter Setup: This menu
choice displays the application rate per meter
revolution determined by the individual meter
calibrationsandallowstheusertoenterdifferent
valuesdirectlyifdesired.Thisscreeniswherethe
pulsesperrevolutionofthemeterrotationsensor
can be entered if a value different than the
factoryconfigurationisneededandtheincrement
rate for on the go application rate changes is
enteredforeachmeter.Thisscreenisalsowhere
thelowmeterRPMalarmpointisset.

Thereisascreenavailableunderthischoiceforeachinstalledmeter.Usethesoftkeytoselect
themetersettings,reviewandadjust.Fourmetersareshownbutmetersnotinstalledcannot
beaccessed.

11. Seeder Stationary Mode: This menu choice
allowstheusertoenterasimulatedgroundspeed
sotheimplementcanbeoperatedstandingstillto
perform operational checks and trouble shoot
problems









FIGURE4.43
FIGURE4.44
FIGURE4.42