User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL54
4.18 MENUSETTINGS
TheSetupMenuisaccessedfromthemainscreen
by pressing any Soft Key to bring up the Soft Key
Menu, then selecting Setup from the Soft Key
Selections.

Pressthe“Setup” key










TheMenuSettingsscreenlists12choices:

1. MuxBus Sensor Setup: This is used to install and remove sensors that operate on the
MuxBus network. These include the ground speed sen sor, the Fan sensors, the Bin Level
sensors,pressureandflowsensors.

NOTE:TheVARControllerlistedisnotusedinthisapplication.

NOTE:ThepressuresensorlistedasaMuxBussensorisavailablebutadifferentsensorthanthe
PackingPressuresensor.Thatsensoris connectedtothehydraulicdrivecontrolmoduleandis
communicatedontheCANnetwork.ItiscalledShankPressureinthelayoutitemselectmenu.
2. Global Settings: Usethis menu selection to set
theunitsofmeasure,language,implementwidth,
the volume of
 the alarm, the backlight and
contrast of the screen, and the master switch
mode


FIGURE4.37
FIGURE4.38