User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL42
4.12 GEARINGUPANDDOWN
The30Seriescomesequippedwithanelectricfeedwherethefeedquantityisinfluencedbya
rotorandthegearsetting;SEE“11.0SEEDINGTABLE”ONPAGES123&124.

NOTE:Anappropriategearmustbeselectedpriortodrilling.

Ifthegearischangedwithseedintheseedhopper,itiseasiesttofirstclosetheshut‐offhatch
and empty out the seed that is in the meter, SEE “4.10 OPENING THE EMPTYING
HATCH/EMPTYINGTHESEEDBOX”ONPAGE39.

1.Pulloutthelockingpin(A).

2.Fitthelockingpinintheinnershaft'shole(B),neartheend.

3.Toswitchfromhightolowgear,rotateandpresstheshaftusingthelockingpin.

4.Toswitchfromlowtohighgear,rotateandpulltheshaftusingthelockingpin.












5.
Fitthelockingpininposition(A)forlowgearandposition(B)forhighgear.
FIGURE4.18  FIGURE4.19
FIGURE4.20
