User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL40
4.11 ROTORREPLACEMENT
The30Seriescomesequippedwithanelectricfeedwherethefeedquantityisinfluencedbya
rotorandthegearsetting;SEE“11.0SEEDINGTABLE”ONPAGES123&124.

The rotor for the required seed output attachment must be fitted prior to drilling. There are
threedifferentrotors
tochoosefrom:arapeseedrotor,agrassrotorandagrainrotor.

1.Switchoffthesupplyofseedtotheseedboxwiththeshut‐offhatchandopentheemptying
hatch,SEE“4.10OPENINGTHEEMPTYINGHATCH/EMPTYINGTHESEEDBOX”ONPAGE39.

2.Pulloutthegearboxlockingpin(A).

3.Removethebearing(B)bytwistingitoutofitssnapmountings.




4.Switchto the requiredrotor.Makesurethattherotorengagescorrectlyin thedriveshaft,
SEEFIGURE4.16.



FIGURE4.13 
FIGURE4.14
FIGURE4.15

FIGURE4.16